Related Manuals for Sunbeam HE4100
Summary of Contents for Sunbeam HE4100
- Page 1 Dual Micathermic Convection Heater 2200 Watt Micathermic Convection Heater Instruction Booklet HE4100 Please read these instructions carefully and retain for future reference.
-
Page 2: Table Of Contents
Contents Sunbeam’s Safety Precautions Safety precautions of your Heater Sunbeam's Total Safety System Features of your Micathermic Convection Heater 4 Using your Micathermic Convection Heater To attach the feet Troubleshooting Guide Care and Cleaning Important instructions – retain for Important instructions – retain for future use. -
Page 3: Sunbeam's Safety Precautions
• The temperature of accessible surfaces may be environments. high when the appliance is operating. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. -
Page 4: Safety Precautions For Your Heater
Important instructions - Retain For Future Use If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. -
Page 5: Sunbeam's Total Safety System
Sunbeam’s Total Safety System Safety auto shutoff Instant tip over cut out If the appliance overheats, for example The instant tip over cut out interrupts the due to the air inlet or outlet grilles power to the heating element if the heater is being accidentally blocked. -
Page 6: Features Of Your Micathermic Convection Heater
Features of your Sunbeam Micathermic Convection Heater Recessed handle and stable handle for easy maneuverability Pressed metal exterior Solid stable feet... - Page 7 3 Heat settings Thermostat controlled operation Cord Storage...
-
Page 8: Using Your Micathermic Convection Heater
To attach the feet The hE4100 heater packaging includes 2 black arched feet and 4 screws to attach the feet to the underside of the heater. Mounting... - Page 9 To attach the feet - continued To mount the feet, align the feet such that the 2 narrow screw recesses are situated to the outside, as in the image below.
-
Page 10: Troubleshooting Guide
Troubleshooting Guide 1. If your heater fails to operate, check the - Check that the thermostat is not set too low. following: Turn the dial clockwise to adjust the electric thermostat. Until the heater restarts. - Make sure the electrical outlet or circuit breaker is working.. - Page 11 You are also Alternatively, you can send a written claim entitled to have the goods repaired or to Sunbeam at the address listed below. replaced if the goods fail to be of acceptable On receipt of your claim, Sunbeam will...
- Page 12 Sunbeam Corporation Limited 2011. ABN 45 000 006 771 Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia Unit 3, Building D 26 Vestey Drive Mt Wellington Auckland New Zealand Sunbeam Corporation is a division of GUD Holdings Ltd. 11/11...