Table of Contents
Advertisement
Installation Procedures
1.
Turn off the printer.
Note:
Connect and disconnect the optional external buzzer while the printer is turned
off. If you connect it while the printer is turned on, the buzzer does not function
correctly.
2.
Clean and dry the printer case where the optional external buzzer will be
installed.
3.
With 2 pieces of the affixing tape combined, peel off the sticker on one
side, and paste it around the center of the attaching surface of the optional
external buzzer.
4.
Connect the cable of the optional external buzzer to the drawer kick-out
connector on the printer.
CAUTION:
Be sure to connect to the drawer kick-out connector on the applicable
printer.
Do not connect both the optional external buzzer and the drawer by
using a splitter or similar device.
Affixing tape
3
Drawer kick-out
connector
Advertisement
Table of Contents
