Power Screw Assembly - GE UCG1600L Technical Service Manual

Power Screw Assembly

NOTE: To access the power screw assembly, the
compactor must be removed from the installation.
NOTE: The following describes the procedure to
remove the left side power screw assembly. The
procedure to remove the right side power screw
assembly is identical.
Power Screw Assembly Removal
1. Remove the ram assembly. (See the Ram
Assembly Removal in the Built-In Compactor
Components section in this guide.)
2. Lower the left front leveling leg and remove the
two 11/32 in. nuts and the Phillips head screws
that hold the frame slide to the frame.
3. Remove the left side screw shield.
Screw Shield
Frame Slide
4. Pull up the stopper and stopper cap and remove
both from the power screw assembly.
5. Place the compactor on a protected surface and
stand the compactor on its top.
6. Remove 5 Phillips-head screws and the bottom
pan.
– 24 –
Power Screw Assembly
Stopper
Stopper Cap
Bottom Pan
(Continued next page)