Motor Assembly - GE UCG1600L Technical Service Manual

Motor Assembly

NOTE: To access the motor assembly, the
compactor must be removed from installation.
Gear Pin
Motor Assembly Removal
1. Disconnect power and remove the drawer.
2. Remove the 3 Phillips head screws and the rear
motor cover from the frame.
3. Remove the 2 Phillips head screws and the side
track shield from the motor cover.
Motor
Motor Gear
Shaft Plate
Wave Washer
Sprocket
Drive Gear
Washer
Ring Clip
Chain
– 20 –
4. Disconnect the motor wire harness and the
black neutral wire from the motor (protector).
Neutral Wire
Track Shield
5. Place the compactor on a protected surface and
stand the compactor on its top.
6. Remove the 3 Phillips head screws and the
bottom pan from the frame.
Bottom Pan
7. Remove the four 3/8 in. bolts that attach the
motor assembly to the frame.
Motor Wire Harness
(Continued next page)