BW Technologies GasAlertClip Extreme Instruction Sheet

BW TECHNOLOGIES
GasAlertClip Extreme
2 or 3 Year Gas Detector
Instruction Sheet
Introduction
The GasAlertClip Extreme gas detector (the detector) is a personal safety
device that warns when hazardous gas exceeds factory set alarm setpoints.
The detector stores and transmits gas alarm event data. It is your
responsibility to respond properly to the alarms.
Gas Detected
Oxygen (O ) Percent by volume (%)
2
Carbon monoxide (CO) Parts per million (ppm)
Hydrogen sulfide (H S) Parts per million (ppm)
2
Sulfur dioxide (SO ) Parts per million (ppm)
2
a Safety Information - Read First
Warning: Substitution of components may impair Intrinsic Safety.
Warning: To prevent ignition of flammable or combustible
atmospheres, disconnect power before servicing.
⇒
Do not activate the detector after the date on the package.
⇒
This product is a gas detector, not a measurement device.
⇒
Perform a self-test each day prior to use.
⇒
Ensure the sensor grill is free of dirt and debris.
⇒
Ensure the sensor grill is not obstructed.
⇒
Periodically test the response of the sensor to gas by exposing the
detector to a target gas concentration that exceeds the low alarm
setpoint. Manually verify that the audible and visual alarms are
activated.
⇒
Periodically calibrate the GasAlertClip Extreme O
D2139/5 (English)
iERP: 119566
© 2005 BW Technologies LP. All rights reserved. Printed in Canada
This instrument contains a lithium battery. Do not mix with the solid
waste stream. Spent batteries should be disposed of by a qualified
recycler or hazardous materials handler.
Parts of the GasAlertClip Extreme
Unit of Measure
1
2
3
4
5
6
.
2
7
ec
Note:
Audible alarm
Visual alarm
Infrared download port
Liquid crystal display (LCD)
Alligator clip
Start/test button
Sensor and sensor grill
Display Elements
1 Maximum exposure in alarm
2
Data transmission
3
High and low alarm setpoints
4
Self-test status
5
Gas type
3 / 6 Alarm condition
7 / 8
Detector life-remaining indicators
1 / 8 Months/hours/days since last maximum exposure
Pushbutton
Pushbutton Description
•
To activate the detector, press and hold C for 5
seconds.
•
Press C within 24 hours of receiving a gas alarm
to view the maximum gas exposure.
•
When Test displays, press and hold C for
C approximately 1 second to activate the self-test.
•
detector, press and hold C
To calibrate the O
2
for approximately 3 seconds.
•
To display the gas alarm setpoints, press C.
•
To transmit the data, press C when Prn and
display.