Download Print this page

Wolf IF15/S Planning Information page 5

Integrated electric fryer module
Hide thumbs Also See for IF15/S:

Advertisement

Planning Information
Integrated Electric Fryer Module
M O D E L I F 1 5 / S
I N S T A L L A T I O N N O T E S
Refer to the illustrations and specifications
for overall dimensions, cut-out dimensions and
installation specifics.
Wolf recommends using 33" (838) wide
cabinets for installation of two 15" (381)
modules side by side. An 18" (457) wide
cabinet is recommended for installation of a
single 15" (381) cooktop or module.
IMPORTANT NOTE: Review specific installation
instructions for product to product capabilities
When multiple cooktops or modules are
installed side by side, refer to the countertop
cut-out dimensions on page 6.
This fryer module must be installed at least
15" (381) away from any open flame
cooking device. The open flame may cause
ignition of oil.
This fryer module must be installed at least
15" (381) away from a Wolf steamer
module, as contact between water and hot
oil may cause burns from steam and hot oil.
A Wolf Cooktop or Pro ventilation hood is
recommended. When installing a ventilation
hood, refer to the specific requirements of the
hood for the minimum dimension to countertop.
Also refer to Ventilation Recommendations in
the Cooktop Ventilation or Pro Ventilation
sections of our website, wolfappliance.com.
Dimensions in parentheses are in
millimeters unless otherwise specified.
IMPORTANT NOTE: Wolf does not recommend
the use of downdraft ventilation with the inte-
grated fryer module.
The Wolf integrated fryer module requires a
separate, grounded 3-wire 240/208 V AC, 60
Hz, 15 amp service with its own circuit breaker.
The unit is provided with a 4' (1.2 m) flexible
3-wire conduit for connection at the electrical
supply. Locate electrical within the shaded area
shown in the Installation illustration on page 4.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
The integrated fryer module must be
installed in a base cabinet with access to the
bottom of the unit to drain the oil through a
manual valve. The consumer must supply a
heat resistant bucket to accept the drained oil.
Refer to the Installation illustration on page 4
for location of the drain outlet.
Refer to the installation instructions
shipped with each Wolf product for detailed
specifications.
This cooktop is intended for indoor use only.
5

Advertisement

loading