IBM 10/100/1000 Base-T Ethernet PCI Installation And Using Manual page 16

10. Press Enter. The system finds and highlights this device driver software.
11. Press F7 to select the highlighted device driver software.
12. Press Enter.
13. The INSTALL ADDITIONAL DEVICE SOFTWARE screen displays. The entry fields
are automatically updated. Press Enter to accept the information.
14. The ARE YOU SURE window displays. Press Enter to accept the information.
15. The COMMAND STATUS screen displays.
v The term RUNNING is highlighted to indicate that the installation and configuration
v When RUNNING changes to OK, scroll to the bottom of the page and locate the
v After a successful installation, SUCCESS displays in the Result column of the
16. Remove the installation media from the drive.
17. Press F10 to exit SMIT.
18. Go to the adapter installation procedure, "Chapter 5. Installing the 10/100/1000
Base-T Ethernet PCI Adapter" on page 13.
6
10/100/1000 Base-T Ethernet PCI Adapter Installation and Using Guide
command is in progress.
Installation Summary.
Installation Summary at the bottom of the page.