Sony DSR-80 Installation Manual page 12

Connection for Cut Editing System
Connection example of the cut editing system when DSR-60/60P is connected with DSR-80/80P or DSR-80/80P is connected with another
DSR-80/80P is shown below.
. Refer to the Operating Instructions of other equipment at the same time for connection.
When ASSEMBLE edit or INSERT edit is selected
at the editor, the EDIT MODE indicator on the
front panel of DSR-80/80P (recorder) lights,
entering the editing mode automatically.
DSR-60/60P
DSR-80/80P
(player)
MONITOR
AUDIO
3
Audio input
Source monitor
Switch setting of DSR-80/80P/60/60P (player) and DSR-80/80P (recorder)
Switch
REMOTE/LOCAL
. Refer to the Operating Instructions of DSR-80/80P for video/audio input of recorder and for audio mode setting.
Note : When the QSDI interface is used for the connection, monitor of the JOG audio cannot be switched to the recorder
monitor even through recorder enters the E-E mode. Therefore, monitor the JOG audio at the player side.
About the reference video signal
The reference video signal which is synchronized with the video signal in use, is necessary and must be input to the REF. VIDEO IN
connector for analog signal editing in order that the built-in TBC works correctly and the stable picture and audio are obtained.
6
1
QSDI OUT
VIDEO REMOTE
OUT 2
(SUPER)
1 2
Composite video input
PLAYER
88:88:88:88
Editing control unit
RM-450/PVE-500 (editing side)
Recorder Player
REMOTE REMOTE
1 75 Z co-axial cable (optional)
2 9-pin remote cable (5 meter long, supplied)
3 RCA plug (optional)
REF. VIDEO
OUT
MONITOR
AUDIO
3
Audio input
REF. VIDEO IN
88:88:88:88 88:88:88:88
888
Main monitor
RECORDER
DSR-80/80P
(recorder)
QSDI IN
VIDEO REMOTE
OUT 2
(SUPER)
1 2
Composite video input