Download Print this page
Sealey ROADSTART Instructions

Sealey ROADSTART Instructions

Emergency power pack 12v 900 peak amps

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Warning:
Refer to
Explosive
Instruction
material
manual
1. SAFETY
Read and understand the general safety and operating instructions before use. The following information is intended to help you keep
the product in top working order.
NOTE – The battery in this unit is a consumable item and its ability to accept charge will reduce over time. We will provide warranty
against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not charged properly before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not
replace the battery even if it is less than one year old.
You can help prolong the life of the battery by following a few simple guidelines.
plug in your new Roadstart to the mains transformer and make an INITIAL charge lasting 38 hours.
Ensure the unit is fully charged before storage.
DO NOT leave the Roadstart for longer than 2 months without putting it on charge.
DO NOT attempt to start a vehicle when the Roadstart battery level lights show red.
DO NOT drop or roughly handle the Roadstart – this will break or disjoin the battery terminals rendering the battery useless and the
warranty void.
DO NOT use any other charger, other than the one supplied, to recharge the battery.
IMPORTANT: To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the
manufacturer of any equipment you intend to use in the vicinity of the battery. Remember to review warning marks on all products and on
engines. Modern vehicles contain extensive electronic systems. Check with the vehicle manufacturer for any specific instructions regarding the
use of this type of equipment on each vehicle. No liability will be accepted for damage/injury where this product is not used in accordance with
all instructions.
1.1. PERSONAL PRECAUTIONS
Ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working

near a lead-acid battery.
Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.

Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.

Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool,

clean running water for at least 15 minutes and seek immediate medical attention.
Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit

current high enough to weld a ring or the like to metal, which may cause severe burns.
1.2. IMPORTANT SAFETY INSTRUCTIONS
Familiarise yourself with the applications, limitations and potential hazards of the RoadStart.

Keep the unit in good working order and condition. Replace damaged parts immediately.

Use only recommended parts. To use unapproved parts may be dangerous and will invalidate your warranty.

The RoadStart must only be opened and checked by qualified service personnel. DO NOT disassemble the unit for any reason.

Keep children and unauthorised persons away from the work area.

Keep work area clean and tidy and free from unrelated materials. Ensure that there is adequate lighting.

If the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.

When not in use re-charge every two months.

DO NOT smoke or allow a spark or flame in the vicinity of the battery or engine.

DO NOT drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.

DO NOT use RoadStart to recharge dry cell batteries that are commonly used with home appliances. These batteries may explode and

cause personal injury and damage to property.
DO NOT charge or boost a frozen battery.

DO NOT use attachments other than those recommended. To do so may risk damage to the unit and other equipment and possible

personal injury.
DO NOT pull or carry the unit by its cables and do not pull the negative and positive clamps from the battery terminals.

DO NOT operate in vicinity of flammable liquids or gases.

DO NOT recharge the unit with plugs, cables or attachments that are damaged. Replace such items immediately.

DO NOT use this product to perform a task for which it is not designed.

© Jack Sealey Limited
INSTRUCTIONS FOR:
ROADSTART® EMERGENCY POWER PACK
12V 900 PEAK AMPS
MODEL NO:
Wear eye
Warning:
protection
Corrosive
substance
IMPORTANT WARRANTY INFORMATION: KEEP YOUR ROADSTART HEALTHY
Original Language Version
RS1312HV
Wear
Warning:
protective
Electricity
Gloves
Use in
Keep away
protect
Well
from sources
From
Ventilated
Rain
Areas
battery could
RS1312HV
Issue: 1 - 15/12/16
of ignition:
explode

Advertisement

loading

Summary of Contents for Sealey ROADSTART

  • Page 1 DO NOT attempt to start a vehicle when the Roadstart battery level lights show red. • DO NOT drop or roughly handle the Roadstart – this will break or disjoin the battery terminals rendering the battery useless and the warranty void.
  • Page 2: Specification

    DO NOT leave the unit in a totally discharged state for an extended period of time as this may result in permanent damage. DO NOT cross-connect the power leads from the RoadStart to the battery. Ensure that positive is to positive and negative is to negative.
  • Page 3: Operation

    Turn on the ignition to start the vehicle. NOTE: If the vehicle does not start after 4 to 5 seconds, allow the RoadStart unit to cool for 3 to 4 minutes, before attempting to jump start the vehicle again. If this is not done, the unit could sustain damage.
  • Page 4: Battery Removal

    5V USB socket The RoadStart is fitted with a 5V 1A USB socket (fig.1.9). To energise the socket, press the worklight/USB selector twice. The USB indicator will light when the socket is live. A further press of the selector will switch the socket off.
  • Page 5 Contact your local solid waste authority for recycling information. Battery Removal For battery removal see section 7. Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705. NOTE: It is our policy to improve products continually and as such we reserve the right to alter data, specifications and component parts without prior notice.

This manual is also suitable for:

Rs1312hvRoadstart rs1312hv