Sealey PRS6400 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
ELECTRICAL SAFETY FOR SMART CHARGER FOR CHARGING ROADSTART BATTERIES
1.1.
WARNING! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products.
If this product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
Electrical safety information. It is important that the following information is read and understood.
1.1.1. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3. Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable. Remove the plug from the socket by maintaining a firm grip on the plug.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or replaced immediately by a
8
qualified electrician.
1.1.4. This product is fitted with a BS1363/A 3 pin plug.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Replace a damaged plug with a BS1363/A 3 pin plug. If in doubt contact a qualified electrician.
Class II products are wired with live (brown) and neutral (blue) only and are marked with the
Class II symbol;
A) Connect the BROWN live wire to the live terminal 'L'.
B) Connect the BLUE neutral wire to the neutral terminal 'N'.
C) After wiring, check that there are no bare wires and ensure that all wires have been correctly connected.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
DO NOT connect either wire to the earth terminal.
Sealey recommend that repairs are carried out by a qualified electrician.
1.2. GENERAL SAFETY
Modern vehicles contain extensive electronic systems. You are required to check with the vehicle manufacturer, for any
specific instructions regarding the use of this type of equipment on each vehicle.
No liability will be accepted for damage/injury, where this product is not used in accordance with all instructions.
PLEASE SAVE THIS OWNER'S MANUAL AND READ BEFORE EACH USE.
This manual will explain how to use the unit safely and effectively. Please read and follow these instructions and precautions carefully.
9
If someone else uses the Roadstart, make they are well informed on how to use it safely, and have read and understood the operating
9
instructions. The longevity of the Roadstart depends on it.
Charge the Roadstart's internal battery immediately after purchase, after each use and as often as possible. It is highly recommended
9
to leave the Roadstart permanently connected to the automatic charger.
Read the entire manual before using this product. Failure to do so could result in serious injury or death.
9
Keep out of reach of children.
9
This Roadstart is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
9
of experience and knowledge, unless they have been given supervision or instruction concerning the use of the Roadstart by a person
responsible for their safety.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
9
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance.
9
DO NOT put fingers or hands into the product.
8
DO NOT expose the Roadstart to rain or snow.
8
Use only recommended attachments. Use of an attachment not recommended or sold by Sealey may result in a risk of fire, electric
9
shock or injury to persons or damage to property.
© Jack Sealey Limited
PREMIER 12/24V 6400A WHEELED ROADSTART®
JUMP STARTER
MODEL NO:
Wear protective Do not expose
clothing to rain
Original Language Version
PRS6400
Use in a well Keep away
ventilated area from sparks
and flame -
battery could
emit explosive
gases
Corrosive Warning!
substance
Recommended fuse rating
PRS6400 Issue:1
5Amp
23/01/23