Table of Contents
Advertisement
3. INSTALLATION
ATTENTION!
The lifting equipment to be used (including ropes, harnesses and eyebolts) must be
suitable to the stated weights of parts also considering any accessories (the weights
of piping).
In the case of bare shaft pump, never connect ropes to the end of the shaft.
ATTENTION!
IN THE EVENT OF PURCHASING THE PUMP ONLY AND COUPLING IT TO AN-
OTHER COMPANY'S MOTOR, THE PERSON PERFORMING THIS COUPLING
MUST ASSURE COMPLIANCE WITH ALL SAFETY REQUIREMENTS.
Do not lift assemblies using the motor eyebolts.
In any case follow the instructions given in the coupling joint booklet and in chapter 5
"MAINTENANCE".
3.1
INSTALLATION OF THE ELECTRIC MOTOR PUMP ASSEMBLY
Fig.8
In this case the electric pump is supplied by the manufacturer already mounted.
Handling must always be performed with lifting equipment of load capacity suita-
ble to the unit (see the weights on the packages). (Fig. 7-8)
TIGHTENING TORQUES NM
Fig.7
7
Advertisement
Table of Contents
