Advertisement
Planning
For planning the layout, measure the perimeter of the building and divide by 8 ft. (2.44m) to determine the required quantity of Tetra
Contour LS systems. See table below for guidelines about cutting resolution.
For seamless designs, accessories are available for straight runs and 90 degree corners.
NOTE: Do not use more than one suffix code for each respective application, as mixing suffix codes may result in appearance variation.
Suffix code can be found on the packaging label.
Tetra Contour LS
SKU
Color
GERDXNLA2 - RD
Red
GEGLXNLA2 - GL
Green
GEBLXNLA2 - BL
Blue
GEWHXNLA2 - WH
White
Tetra Contour LS
Tetra Contour LS extension
1
If it is necessary to cut the Tetra Contour LS for a better fit,
refer to the Cutting Resolution table above.
NOTE: Tetra Contour LS can only be cut on wires.
NOTE: Tetra Contour LS extension sections can only be cut
on "Cut Here" markings.
Attaching Contour Sections
NOTE: Tetra Contour LS is intended for straight runs.
Space mounting clips
18 inches (457mm) apart
1
Install one mounting clip at each end and then a minimum
of one mounting clip every 18 inches (457mm).
NOTE: Standard neon mounting hardware can also be used.
Cutting Resolution Table
Cutting Resolution
8 inches (203mm)
8 inches (203mm)
8 inches (203mm)
8 inches (203mm)
Tetra Contour LS extension
SKU
Color
GERDXNAA2 - RD
Red
GEGLXNAA2 - GL
Green
GEBLXNAA2 - BL
Blue
GEWHXNAA2 - WH
White
Electrical Grade Silicone
2
If Tetra Contour LS sections are cut, apply electrical grade
silicone to exposed wires and attach end cap.
Risk of damage. Must use electrical grade silicone.
2
Starting from one end, attach the Tetra Contour LS to the
mounting clips. Secure light guide by twisting tie-wire around
the mounting clip and light guide.
NOTE: Wires can be concealed by tucking wires between
mounting clips and Tetra Contour LS system.
Cutting Resolution
2.67 inches (68mm)
2.00 inches (51mm)
2.00 inches (51mm)
2.00 inches (51mm)
CAUTION
Advertisement
