Advertisement
Quick Links
GE
Lighting Solutions
Contour LS
Tetra
®
LED Lighting System
Tools and Components
1
1
6
7
9
imagination at work
2
3
2
3
8
8
e f
t e
2 (
4 .
4
) m
1
6
n i
h c
s e
4 (
0
6
m
) m
10
4
4
5
Installation Guide
Tools required:
1
Wire stripper/cutter
2
Tape measure
3
Electrical grade silicone
4
Cordless drill
Components required:
1
UL approved 18 AWG (0.82mm
supply wire
2
End Caps
3
Weather Boxes
4
Light Guide Mounting Clips
5
22 AWG (0.33mm
) tie-wire
2
6
#6, #8 or #10 (M2, M3 or M4) self
drilling pan headed screws
7
UL approved twist-on wire
connectors fitting both 18 and 20
AWG wire (0.82mm
, 0.52mm
2
8
Tetra 24 Volt Power Supply
®
9
®
Tetra
Contour LS
10
Optional: Tetra
®
Contour LS
extension
24
Volt
)
2
)
2
Advertisement
Related Manuals for GE Tetra Contour LS
Summary of Contents for GE Tetra Contour LS
- Page 1 Installation Guide Lighting Solutions Volt Contour LS Tetra ® LED Lighting System Tools and Components Tools required: Wire stripper/cutter Tape measure Electrical grade silicone Cordless drill Components required: UL approved 18 AWG (0.82mm supply wire End Caps Weather Boxes Light Guide Mounting Clips 22 AWG (0.33mm ) tie-wire #6, #8 or #10 (M2, M3 or M4) self...
- Page 2 Tetra Contour LS Tetra Contour LS extension Electrical Grade Silicone If it is necessary to cut the Tetra Contour LS for a better fit, If Tetra Contour LS sections are cut, apply electrical grade refer to the Cutting Resolution table above.
- Page 3 3/8 in. (10mm) gap Continue attaching all the sections to the remaining Plug together all adjacent Tetra Contour LS sections and mounting clips, leaving a 3/8 inch (10mm) gap between tuck wires behind Tetra Contour LS sections or behind sections to allow for expansion or contraction.
-
Page 4: Troubleshooting
1 - 8 8 8 - 6 9 - 4 3 - 5 3 3 GE Lighting Solutions is a subsidiary of the General Electric Company. Tetra is a trademark of GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company.