Safety Instructions; Software Version; Installing The Power Supply - Danfoss Link HP-kit Installation Instructions Manual

Installation manual

Safety instructions

Installation must be carried out in accordance with applicable laws and regulations, as well as
C
these instructions.
C The cables are live and may cause fatal electrical shock. The heat pump power supply must be
switched off before commencing electrical installation.

Software version

1. Check the software version on the DHP-AQ control
display. Press the left arrow on the heating pump
control until the display changes to "Service menu".
2. Press "minus" until the cursor reaches the "Version"
menu.
3. Press the "right arrow". This will bring up the
software version in the display. Link
requires a softwareversion of 2.2 or newer.
Location
The power supply must be mounted inside the heat pump control in the prepared holes in the electrical
panel. The DCM03 device is designed to be mounted on a wall as close as possible to the heat pump. The
distance is limited by the length of the DCM03 connection cable.

Installing the power supply

1. Switch off the power to the heat pump.
C
Read the safety instructions before connect-
ing any wiring.
9
Danfoss Link™ HP kit
™
for DHP-AQ
VIIFR102
Service menu
- Installation
- Version
<
© Danfoss 03/2014
≥ 2.2
+
>
_