Service Functions - Danfoss Link HP-kit Installation Instructions Manual

Installation manual
Connection to Danfoss Link™ CC
C Before connecting to a power outlet, make sure that the electrical installation has been carried out
correctly and that there is no risk of injury or damage.
• Start the heat pump
• Remove the front panel from the Danfoss Link™ CC by carefully
pulling it off. Pull near the edges of the panel.
• Press the Setup button for three seconds to open the service
.
area
Note!
The heat pump must be added to the network as a service unit. For more information about connecting to
networks see the accompanying Danfoss Link™ CC Installation Manual.
Add any dedicated repeaters (CF-RU) BEFORE adding the heat pump to the wireless network.

Service functions

1
Rooms and units
Click here to add the DCM03 module to
Note!
During installation, the distance between Danfoss Link™ CC and DCM03 must not exceed 1.5 metres.
Connecting other units to Danfoss Link™ CC, wireless connection
Connect other service and room units, e.g. HC floor heating and living connect radiator thermostats. Start
with the service units. For more information about connecting other units, see the accompanying Danfoss
Link ™ CC installation instructions.
13
Danfoss Link™ HP kit
Rooms and units
2
Add service unit
?
VIIFR102
Add service unit
3
?
Danfoss Link ™CC.
© Danfoss 03/2014
Start registration
?