Advertisement
GB
SYMBOLS
The following symbols are displayed on the ma-
chine in order to remind you about the safety pre-
cautions and attention necessary when using the
machine.
The symbols mean:
Warning!
Read the instruction and safety manual be-
fore using the machine.
Warning!
Do not put hands or feet under the cover of
the machine when it is running.
Warning!
Beware of objects being flung out. Keep
spectators away.
Warning!
Before starting any repair work, remove the
spark plug cable from the spark plug.
ASSEMBLING
MOWER DECK
1. Fit the attachments D on the front axle projections
by means of washers and locking clips (fig 1).
2. Fit the attaching arms of the mower deck on the
attachments on the machine.
3. Place on the v-belt between the belt pulley of the
mower deck and the centre belt pulley F of the ma-
chine (fig 2).
4. The tensioning roller G should come on the left
side of the belt as viewed from the driving seat (fig
2)
5. Then pull the mower deck forwards so that the
holes in the attaching arms come in line with the
holes in the attachments on the machine.
6. Fit the bolts and tighten them.
7a. Park -1999:
Hook the tension roller spring H into the floor on
the right-hand side (fig 2).
3
ENGLISH
7b. Park 2000-
Hook the tension roller spring H into the fastener,
just behind the front right wheel (fig 2).
8. Lift up the mower deck and hook the spring on
the implement lifting bar.
When changing the v-belt or removing the mower
deck, proceed in the reverse order.
ADJUSTING
1. Make sure that the tyres have the correct inflation
pressure:
Front: 0,6 bar (9 psi).
Rear: 0,4 bar (6 psi).
2. Stand the machine on a level floor. Slacken the
screws K and adjust the mower deck so that the
front and rear edges L come at the same distance
from the floor (fig 3). Tighten the screws.
Points 1 and 2 must be carried out to ensure that the
mower deck mows evenly.
MOWING HEIGHT
The mower deck has 5 fixed mowing heights, from
40 mm to 80 mm.
N.B. The stated mowing heights apply when the
machine is standing on firm ground.
MOWING HINTS
For the best effect follow this advice:
- mow regularly.
- use full throttle on the engine.
- keep the underside of the mower deck clean.
- use sharp blades.
- do not mow wet grass.
Neither the motor nor the mower deck
may be serviced unless:
- the motor is shut off.
- the ignition key is removed.
- the ignition cable is removed from the
spark plug.
- the parking brake is engaged.
- the mower deck is disengaged.
USE
MAINTENANCE
Advertisement
