Setup; Warnings - Graco E Series Instructions-Parts List Manual

1. Connect Hose and Gun. Refer to
NOTE: When tightening fittings at the pressure control,
hold one wrench firmly on the hex of the pressure
control fitting to keep it from rotating. Use an-
other wrench to tighten the mating fitting.
a. Remove the cap from the filter outlet nipple and
screw the 15.2 m main fluid hose onto the nipple.
b. Connect the whip hose between the fluid hose
and the gun inlet connection.
c. Don't use thread sealant, and don't install the
spray tip yet!
WARNING
If you are supplying your own hoses and spray
gun, be sure the hoses are electrically conduc-
tive, that the gun has a tip guard and that each
part is rated for at least 207 bar Working Pres-
sure. This is to reduce the risk of serious bodily
injury caused by static sparking, fluid injection or
over-pressurization and rupture of the hose or
gun.
2. Two Gun Hookup. Remove the cap from the 1/4.
-
See Fig
cessory hose and gun. See Fig 6-2.
CAUTION
To avoid damaging the pressure control, which
may result in poor equipment performance and
component damage, follow these precautions:
long.
2. Never use a wire braid hose as it is too rigid to
as
act a pulsation dampener.
3. Never install any shutoff device between thefil-
ter and the main hose. See Fig
Always use the main filter outlet for one gun op-
4.
eration. Never plug this outlet.
3. Fill Packing Nutwet-Cup. See Fig 6-1
Fill the packing nut/wet-cup
Throat Seal Liquid (TSL), supplied.
4. Check the Electrical Service
a. Be sure the electrical service is properly rated for
your sprayer and that the outlet you use is prop-
erly grounded.
b. Have a licensed electrician attach an appropri-
ate plug to the power supply cord.
c. Use an extension cord which has 3 wires of a
long. Longer lengths may affect sprayer per-
formance.
6

SETUP

Fig
6 - 1
6-1
-and attach an ac-
full with Graco
1/3
Fig
6- 1
. . . ^. . .
SECONDARY HOSE
DO NOT INSTALL ANY
SHUTOFF DEVICE
HERE
\
PRESSURE
DRAIN VALVE