Graco E Series Instructions-Parts List Manual page 22

WARNING
Before doing this procedure, follow the Pressure
Relief Procedure Warning on page 21 to reduce
the risk of a fluid injection injury, splashing in the
eyes or on the skin, injury from moving parts, or
electric shock.
and 22-2
Refer to Fig
from the filter stud (31
(337)
2. Use the 13 mm socket wrench to remove the three
Screws holding the pressure control to the
(44)
frame.
3. Remove the pressure control mounting bracket (89)
using a Phillips screwdriver.
4. Disconnect the power supply cord wires from the
control box terminal strip (336) using a screwdriver.
5. Install the new power supply cord
verse order of disassembly.
6. Have a licensed electrician install a new plug on the
other end of the cord. Be sure to follow all local codes
regarding the type of plug to use.
FILTER REPLACEMENT
Relief Procedure Warning on page 21 to reduce
the risk of a fluid injection injury, splashing in the
eyes or on the skin, injury from moving parts, or
electric shock.
Fig 22-2
Refer to
1. Remove the pressure control cover and screws.
2. Use a needle nose pliers to remove the four wires
the
from filter (310).
Use the M8 wrench to remove the lower nut and
3.
lockwashers (337, 338) on the outside of the
pressure control box.
Remove the old filter and install a new one in the
4.
reverse order of disassembly.
22
POWER SUPPLY CORD REPLACEMENT
0).
(31 1) in the re-
Fig 22-1
311
Fig 22-2