Toro 51830 Operator's Manual page 18

Problem
The tool does not run or run continuously.
It is difficult to remove the battery pack
from the tool.
Possible Cause
1. There is moisture on the leads of the
battery pack.
2. The battery is not fully installed into the
tool.
1. The battery pack/tool is new or there
is corrosion in the battery terminals
and/or the terminals on the tool.
18
Corrective Action
1. Allow the battery pack to dry or wipe it
dry.
2. Remove and then replace the battery
into the tool making sure that it is fully
installed and latched.
1. Clean the terminals on the battery
pack and the tool with a dry rag. Then
apply dielectric grease to the battery
terminals; do not use any other type
of lubricant as it can damage the
terminals.