Toro 51830 Operator's Manual
Flex-force power system 14in or 16in 60v max string trimmer.
Hide thumbs
Also See for 51830:
- Manual (65 pages) ,
- Operator's manual (25 pages) ,
- Operator's manual (68 pages)
Table of Contents
Related Manuals for Toro 51830
Summary of Contents for Toro 51830
- Page 1 Form No. 3426-191 Rev D Flex-Force Power System ™ 14in or 16in 60V MAX String Trimmer Model No. 51830—Serial No. 319000001 and Up Model No. 51830T—Serial No. 319000001 and Up *3426-191* D Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Important Safety Instructions
Model 88625 (provided with Model 51830) or 88660 or 88675. Using this product for purposes other than II. Preparation its intended use could prove dangerous to you and Keep bystanders and children away from the bystanders. - Page 3 Dress properly—Wear appropriate clothing, battery pack above 68°C (154°F) or incinerate including eye protection; long pants; substantial, it. Replace the battery pack with a genuine Toro slip-resistant footwear; rubber gloves; and battery pack only; using another type of battery hearing protection. Tie back long hair and do not pack may cause a fire or explosion.
- Page 4 Do not attempt to service or repair the appliance, battery pack, or battery charger except as indicated in the instructions. Have an Authorized Service Dealer perform service using identical replacement parts to ensure that the product is safely maintained. Store an idle appliance indoors in a place that is dry, secure, and out of the reach of children.
-
Page 5: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal137-9463 137-9463 1. The battery pack is 3. The battery pack is over charging. - Page 6 decal139-5214 139-5214...
- Page 7 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Screws (not included) Mount the battery charger (optional). Allen wrench Unfold the handle. Auxiliary handle assembly Install the auxiliary handle. Guard Install the guard. Note: The battery pack is not fully charged when you purchase it.
-
Page 8: Unfolding The Handle
Unfolding the Handle Parts needed for this procedure: Allen wrench Procedure Unfold the handle (A of Figure Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts together (B and C of Figure Note: The locking button clicks into the slotted hole when the shafts are secured (D of... -
Page 9: Installing The Auxiliary Handle
Installing the Auxiliary Handle Parts needed for this procedure: Auxiliary handle assembly Procedure Separate the auxiliary handle from the handle plate by removing the 4 socket head screws using the provided Allen wrench (A of Figure Line up the auxiliary handle with auxiliary handle plate on the trimmer handle (B of Figure Secure the auxiliary handle to the handle plate with the 4 socket head screws previously removed (C of Figure... -
Page 10: Installing The Guard
Installing the Guard Parts needed for this procedure: Guard Procedure Using the provided Allen wrench, remove the 2 socket head screws, 2 washers, and 2 spacers from the trimmer base (A of Figure Align the guard onto the trimmer base (B of Figure Secure the guard onto the base of the trimmer with the 2 socket head screws, 2 washers, and 2 spacers previously removed (C of... -
Page 11: Product Overview
Product Overview Operation Specifications Starting the Trimmer Make sure that the vents on the trimmer are Appropriate Temperature Ranges clear of any dust and debris. Charge/store the battery pack 5°C (41°F) to 40°C (104°F)* Use the battery pack at -30°C (-22°F) to 49°C (120°F) Use the trimmer at 0°C (32°F) to 49°C (120°F) Store the trimmer at... -
Page 12: Charging The Battery Pack
Charging the Battery Pack Important: The battery pack is not fully charged when you purchase it. Before using the tool for the first time, place the battery pack in the charger and charge it until the LED display indicates the battery pack is fully charged. -
Page 13: Advancing The Line Manually
Advancing the Line Using the Bump Feed Run the tool at full throttle. Tap the bump button on the ground to advance the line. The line advances each time the bump button is tapped. Do not hold the bump button on the ground. -
Page 14: Operating Tips
Adjusting the Cutting Swath The trimmer comes from the factory with a cutting swath of 36.6 cm (14 inches) as shown in A of Figure Refer to the following instructions to adjust the swath to 40.6 cm (16 inches) as shown in D of Figure Remove the swath blade from the bottom of the guard by removing the 2 screws holding it in place using the provided Allen wrench (B of... -
Page 15: Maintenance
Replacing the String Use only 2 mm (0.080 inch) diameter monofilament string (Toro Part No. 88611) or 2.4 mm (0.095 inch) diameter twisted monofilament string (Toro Part No. 88612). Remove the battery pack. -
Page 16: Preparing The Battery Pack For Recycling
Call2Recycle seal, please contact your local municipality for more information on how to responsibly recycle the battery. If you are located outside of the US and Canada, please contact your authorized Toro distributor. -
Page 17: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The tool does not start. - Page 18 Problem Possible Cause Corrective Action The tool does not run or run continuously. 1. There is moisture on the leads of the 1. Allow the battery pack to dry or wipe it battery pack. dry. 2. The battery is not fully installed into the 2.
- Page 19 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.