Table of Contents
Advertisement
3. Use
DreamBoxEdit
Service List (channel list) from our forum. Anytime you
scan transponders you erase info in the service list.
Dish Network transponders cannot be scanned so don't
try. If the desired satellites are in the service list on this
forum use it. If you need to add satellites, scan them in
one at a time using automatic scan.
4. Setup
'Satellite
5. Reload service list with DreamBoxEdit. Repeat this step
anytime you make changes in 'Satellite Configuration'.
6. Reboot if you plan to tune FTA only, otherwise proceed
to step 7.
This will get you the free-to-air channels. If you plan to
test other channels (which we don't encourage or
condone your doing) then you need to apply keys. The
key files are SoftCam.Key and AutoRoll.Key for
Radegast and Autoupdate, camd_cfg, Keylist,
replace.list, and three nagra files for Evocamd.
Newcamd uses seven nagra files and rsakeylist, keylist,
and mappings. These file names are case-sensitive!
Most images come with camd_cfg already present. Do
not overwrite this file.
7.
Load the keys
Error Messages:
If the screen says 'Service not Found' then you need to correct
your setup of satellites in Satellite Configuation, FTP a new
Service/Channel list to the DreamBox, replace your switches, or
check your wiring.
If the screen is black without messages then you have an emu
problem and need to check where you FTP'ed the "Key" files
and/or reboot.
to load the most recent DB Nation
Configuration'.
for Newcamd with DCC.
Advertisement
Table of Contents
