Table of Contents
Advertisement
We will provide you with an example to demonstrate how this
should be done. This example will be for 2 LNBs, one linear
standard and one circular, connected to a 22kHz switch tuning
satellites at 82, 91, 110, 119, 148, 97, 105, and 121 degrees.
Equipment:
1. 30 inch or larger dish with a circular LNB for R and L
polarization and linear standard LNB for H and V
polarization. A universal linear LNB will not work with the
22kHz switch.
2. 22kHz switch. (A DiSEqC switch will also work but a
simple on and off switch such as a 22kHz switch will work
just as well.)
3. Rotor. We recommend the Stab HH series. Some of the
others lose position memory.
Procedure:
1. Mount the dish and make sure everything is level and
plumb.
2. Install the linear LNB in the center of the dish.
3. Install the circular LNB just to the left of the linear LNB as
you are looking at the front of the dish.
4. Connect the circular LNB to the 'OFF' pole of the switch
and the linear LNB to the 'ON' pole of the switch.
5. Connect the RG6 cable from the switch to the Rotor and
another from the Rotor to the DreamBox.
6. Aim the dish in the approximate direction of your first
satellite.
7. Sometimes we have a rotor version of the DBNA image in
the Forum. If there is, and you downloaded the newest
'Rotor' version of our DBNA image, there is nothing you
Advertisement
Table of Contents
