Page 1
BCD500SL/BL/IV/R- 50 cm Dual Fuel Cooker...
Page 2
User Manual for your Baumatic BCD500SL/BL/IV/R-EU 50 cm Dual fuel cooker NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
26 – 27 Gas connection Gas safety Gas connection 28 – 29 Gas adjustment (conversion to LPG for the hob top) Minimum flow adjustment for hob gas taps My appliance isn’t working correctly 32 – 33 Baumatic consumables Contact details...
Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment.
Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this ooklet, please contact the Baumatic Advice Line.
Page 6
Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed to touch the appliance at any time. During and after use, all surfaces will become hot. o If it is necessary for younger family members to be in the...
Page 7
o Do not store chemicals, food stuffs, pressurised containers in or on the cooker or in cabinets immediately above or next to the cooker. o Do not heat up unopened food containers, as pressure can build up which may cause the container to burst. o Do not place flammable or plastic items on or near the hob burners, these types of materials should also not be placed in the oven or the compartment below the oven.
Page 8
Please see the specific section of this booklet that refers to installation. o Baumatic Ltd. declines any responsibility for injury or damage, to person or property, as a result of improper use or installation of this appliance.
pecificatio Product dimensions: Height: 850 - 870 mm Width: 500 mm Depth: 600 mm Product specifications: o 4 zone gas hob: o 1 x 3.00 kW rapid burner o 2 x 1.75 kW semi-rapid burners 1 x 1.00 kW auxiliary burner o Flame failure safety dev ice on each burner o Pushbutton ignition...
Standard accessories o 2 x Enamelled baking trays o 1 x Shelf o LPG convers ion jets Optional extra: o BPS2 Pizza sto Electrical details Rated Voltage: 220 - 240 Vac 50 Hz Supply Connection: 16A (dou ble pole switched fused outlet with 3mm co ntact gap) Max Rated Inputs...
Control Panel Thermostat control k ob (oven) o Use this control knob to control the temperature in the oven. Thermostat control k nob (hob) o Use the control knob of the relevant burner to set the temperature intensity. Oven function control knob o Use this control knob to select the desired cooking function for the oven.
ven timer ) Alarm stop icon (press minus button to stop alarm). 2) Timer minus button. ) Timer plus button. ) Time-setting mode indicator (press plus and minus buttons gether to enter this mode). Setting and using the oven timer Setting the time of day Before using the oven for the first time you should set the time of day.
Setting the minute minder function You are able to set the minute minder at any time, regardless of whether an oven function has b een selected. You can set a period of me using the minute minder function and an alarm will sound when this period of time has elapsed.
o Outer parts of the oven should be cleaned with warm soapy water, using either a spo nge or soft cloth. No abrasive cleaners should be used. Selecting an oven function The oven fun ction control knob should be used to select the particular ode of cooking that you require.
Thermostat control knob The oven thermostat control knob sets the required temperature of the oven. It is possible to regulate the temperature within a range of 75 - 250°C. Cooking guidelines o Please refer to the information give n on food packaging for guidance on cooking temperatures and times.
Warnings o Keep the oven door closed when using any of the cooking functions, including all grill functions. o Do not use aluminium foil to cover the enamelled baking tray or heat items wrapped in aluminium foil under the grill. The high reflectivity of the foil could potentially damage the grill element.
Using the hob top burners o Each zone on the gas hob top is controlled by a control knob. o To turn on a cooking zone use the relevant control knob for the zone you wish to use. o Press and turn the control knob to the large flame position.
o Cook vegetables with as little water as possible, to reduce cooking times. IMPORTANT: Always place pans centrally over the hob burners and position them so that the handle s cannot get accidentally caught or nocked off. You should also make sure that the handle is not over one of the other hob burner flames.
Any damage that is caused to the appliance by a cleaning product will not be fixed by Baumatic free of charge, even if the appliance is within the guarantee period. Cleaning the gas hob top o Remove the dirty pan supports from the hob and place in warm soapy water for some time.
Maintaining the enamelled pan stands o IMPORTANT: Make sure that the hob surface and pan stands have cooled before you attempt to touch them. o Wipe the pan stands over with a soft, damp cloth that has been put into warm soapy water. The cloth should be wrung out after being taken out of the soapy water.
Removing the oven door for cleaning To facilitate the cleaning of the inside of the cooker and the outer frame of the oven, the door can be removed as follows:- o The hinges (A) have two movable bolts on them (B). o If you raise both of the movable bolts (B), then the hinges (A) are released from the oven housing.
Installation The installation must be carried out by a suitably qualified person, in accordance with the current version of the following. o UK Regulations and Safety Standards or their European Norm Replacements. o Building Regulations (issued by the Department of the Environment).
Page 23
(including the burners). o Baumatic Ltd. do not recommend that the cooker is positioned below wall cupboards, as the heat and steam from the appliance and what is being cooked, may damage the cupboard and its contents.
o The cooker is fitted with four feet that can be adjusted to match height your kitchen cabinets. o If the cooker is not level or is unstable due to an uneven floor surface, use the adjustable feet to alter each corner until the cooker is level.
o Decide on a suitable wall location for fitting the anchor brackets directly behind each cooker safety chain. o Hold the chain anchor up to the wall where it will be required and mark the fixing holes. o Drill the fixing holes and fix the chain anchors to the wall using the screws provided and suitable wall plugs for the type of wall being fixed to.
o Insert the screw head into the top hole of the anchor bracket by tilting it sideways so that it is at an angle to the top hole when it is inserted. o When the screw head is fully engaged in the bracket, tilt it upwards so that it is straight, and tighten the hex nut to secure the end chain link into position.
Conversion for use on LPG and other gases must only be undertaken by a qualified person. For information on the use of other gases, please contact the Baumatic Advice Line. o The cooker must be installed by a qualified person, in...
Gas Safety (Installation and Use) Regulations o It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the Gas Safety Installation and Use Regulations. o It is in your interest and that of safety to ensure compliance with the law.
Page 29
o Connection to the cooker should be made with an approved appliance flexible connection to BS 669. o If the cooker has been converted for use with LPG, then it should be connected to the gas supply using an appropriate bayonet type hose.
Gas adjustment (Conversion to LPG for the hob top) All work must be carried out by a GASSAFE registered engineer. IMPORTANT: Always isolate the cooker from the electricity supply before changing the injectors and/or adjusting the minimum flow of the burners. o Remove the pan supports, burner cap and burner rings.
Minimum flow adjustment for hob gas taps All work must be carried out by a GASSAFE registered engineer. o Ignite the large (rapid) burner and set the control knob to the minimum position. o Remove the control knob to access a small adjusting screw. o Using a suitable screwdriver, turn the screw clockwise to decrease the flow of gas and make the flame smaller.
My appliance isn’t working correctly o The oven isn’t coming on. * Check that the oven is connected to the power supply properly. * Check that you have selected a cooking function and a cooking temperature. o There appears to be no power to the oven and grill. * Check that the appliance has been connected to the electrical mains supply correctly.
Page 33
Or any installation other than the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the...
BC005 Stainless Steel Cleaner and Protector (250ml) o BC007 E-Cloth – General Purpose Cloth o BC008 Microwave Cover To order a Baumatic consumable product please call 0123 5437 244 and quote the product code. You can also order online from eshop.baumatic.co.uk...