Table of Contents
Advertisement
Load Cell Handling
WD600 is designed for low-to-medium capacity operation and is constructed using two
load cells. Although the load cells are protected by shipping screws that keep the cells
from moving, care should be taken when handling the scale to avoid damaging the cells.
The screws are bolts about 38 mm (1.5") long located beneath the load cell mount pads
and threading into the load cell.
When handling the WD600 during installation and setup, make sure the shipping screws
remain in place.
Reinstall both shipping screws during maintenance or prolonged shutdown.
Installation Precautions
The following precautions should be observed when handling the scale.
•
Do not pry on the weighbridge, its mountings, or the cells directly.
•
Do not stand or lean on the scale.
•
Avoid shock from blows of a hammer when trying to position the scale during
installation.
•
Do not lift the WD600 by its load cells.
7ML19985KM01
weigh deck
load cell
bottom load cell mount
WD600 - INSTRUCTION MANUAL
belt
top load cell mount
overload screw
shipping screw
Page 7
Advertisement
Table of Contents
