Micronics PCI/ISA System Board D6-IN User Manual page 52

Message Possible Cause
MONITOR TYPE Monitor type not
DOES NOT MATCH correctly identified in
CMOS Setup.
OPERATING Operating system
SYSTEM NOT cannot be located on
FOUND Drive C: or Drive A:
PARITY CHECK 1 Parity error found in the
nnnn system bus.
PARITY CHECK 2 Parity error found in the
nnnn I/O bus.
PREVIOUS BOOT Previous POST did not
INCOMPLETE - complete successfully.
DEFAULT
CONFIGURATION
USED
REAL TIME CLOCK Real-time clock failed
ERROR BIOS test.
SHADOW RAM Shadow RAM failed.
FAILED AT OFFSET
SYSTEM BATTERY System battery died.
IS DEAD
SYSTEM CACHE External (L2) cache
ERROR - CACHE failed BIOS test.
DISABLED
SYSTEM CMOS System CMOS has been
CHECKSUM BAD - corrupted or modified
RUN SETUP incorrectly.
SYSTEM RAM System RAM failed.
FAILED AT
OFFSET: nnnn
SYSTEM TIMER Timer test failed.
ERROR
Solution
Run Setup and enter
correct monitor type.
Check Setup to see if
Drive A: and C: are
properly configured, or
put a bootable disk in
Drive A:
Check Setup. Board
repair may be required.
Check Setup. Board
repair may be required.
Run Setup, load default
BIOS settings, make any
necessary adjustments,
and save the changes
May require battery
replacement or board
repair.
May require repair of
system board.
Replace the system
battery and run Setup to
reconfigure the system.
System will still run, but
slower. Replace cache
at convenience.
Run Setup and
reconfigure the system.
Replace defective RAM.
Requires repair of system
board.