Hdmi-Utpro-Rx Specifications; Common Applications; Configuration Information And Control Options - AMX HDMI-UTPRO-0808 Instruction Manual

HDMI-UTPRO-RX Specifications

HDMI-UTPRO-RX Specifications
Parameter
Approvals
AC Power
DC Power
Power Consumption
Thermal Dissipation
Operational Temperature
Humidity
MTBF
Serial Port
IR Control (Optional)
HDMI Output Connector
RJ-45 Input Connector
Dimensions
Weight per Module
* We recommend using a regulated power supply for the HDMI-UTPRO-RX. If you exceed the specified voltage level for
the power jack on the RX, the warranty will be void.
AMX reserves the right to modify its products and their specifications without notice.

Common Applications

Whether your displays are across the room, on the other side of the house, or in a classroom down the hall, your sources
can be distributed to up to 8 different displays located remotely. In addition, since UTPRO signals are carried over
commonly available Unshielded Twisted Pair (UTP) cable, the HDMI-UTPRO-0808 is also an extremely cost effective
solution to install.

Configuration Information and Control Options

Routing Configuration Information
The HDMI UTPro systems specify two identical virtual matrices for switching signals: VM 0 = All and VM 1 = Video.
These two VMs function the same for this product. Additional VMs can be created with XNConnect configuration
software as one way to deal with sources with limited sink support (see page 65 and page 119).
Configuration Options


Instruction Manual – HDMI-UTPRO-0808
UL, cUL, CE, FCC Class A, RoHS, WEEE
100 VAC to 240 VAC, single phase (50 Hz to 60 Hz)
12 V to 24 V (+/-10%, desktop power supply included*)
12 Watts, fully loaded
41 BTU/hr, fully loaded
32° F to 113° F (0° C to 45° C)
0 to 90% non-condensing
203,000 hours (combined set of 8 RX modules)
Bi-directional RS-232
Baud rates 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200 (default 9600)
RJ-12 connector
IR Rx Jack: 3.5 mm input port for connection of an IR03 Receiver module (see page 15).
"MIO" protocol is loaded as the default.
IR Tx Jack: 3.5 mm output port for connection of an IR01 Emitter module (see page 15).
The *.IRL file must be loaded for the destination device (see page 98).
For information on compatible IR remote controls, see page 16 and page 18.
HDMI connector connects via HDMI cable to destination device
RJ-45 connector connects via UTP cable to RJ-45 output connector on the
HDMI-UTPRO-0808 enclosure
3.8 in. (9.69 cm) depth
6 in. (15.24 cm) width
1 in. (2.54 cm) height
Approximately 1.5 lbs (0.68 kg) (for shipping weight, see enclosure specifications)
The WebConsole can be used to configure the master connection for the HDMI UTPro, as well as networking
and time settings. Refer to the "HDMI UTPro WebConsole" chapter on page 69 for details.
Use NetLinx SEND_COMMANDs to configure and control the HDMI UTPro. Refer to the "HDMI UTPro
NetLinx Programming" chapter on page 83 for programming details.
Overview and General Specifications
Value
22