Omron NJ Series Startup Manual page 52

3 Setting Up a Single-axis Servo System
2
Click the Transfer to Controller Button.
Click the
3
Click the Yes Button.
Click the
The operating mode changes to PROGRAM mode, and the Sysmac Studio starts transferring
the project to the CPU Unit. During the transfer, a progress bar appears in the Synchronize
Pane.
4
The following dialog box is displayed when the transfer is completed. Click the No Button.
Do not change to RUN mode at this time (i.e., remain in PROGRAM mode).
Click the
3-26
Button.
Button.
Button.
NJ-series Startup Guide for Motion Control (W514)