Advertisement
MAINTAINING YOUR HEATER
Clean heater at least every 6 months or as required. The heater must be
inspected every 6 month or more if conditions warrant it. It is essential that
the heater is not operated with an accumulation of dust, dirt or debris on the
heater or inside the heating chamber.
1. Turn off power at the main disconnect panel.
2. Wait for the heater to cool.
Any service other than cleaning should be performed by an authorized
service representative.
High-temperature safety shutoff
All Frost Protection heaters come with a built-in high-temperature safety shutoff that stops electricity
flowing to the heater if it gets too hot inside. This automatically resets after cooling.
FP051T FP052T (single element)
L2/N
L1
For more effective and safer operation and to
prolong the life of the heater, read the Owner's
Guide and follow the instructions. Failure to
properly maintain the heater will void any warranty
and may cause the heater to function improperly.
LIMITED TWO YEAR WARRANTY: Cadet will
repair or replace any Frost Protection (FP) heater
found to be defective within two years after the
date of purchase.
These warranties do not apply:
1. Damage occurs to the product through improper
installation or incorrect supply voltage;
2. Damage occurs to the product through
improper maintenance, misuse, abuse, accident,
or alteration;
3. The use of unauthorized accessories or
unauthorized
components
alteration and voids all warranties. Refer to Cadet
website or call customer service at 855.223.3887
or 360.693.2505 for list of authorized accessories
and components.
If you are uncomfortable working with electricity, running electrical supply
wire or installing a circuit breaker, please consult a licensed electrician.
Reduce-Reuse-Recycle
This product is made primarily of recyclable materials. You can reduce your carbon footprint by recycling
this product at the end of its useful life. Contact your local recycling support center for further recycling
instructions.
To register your product, visit
©2019 Cadet
Printed in USA
CLEANING INSTRUCTIONS
INTERNAL HEATER WIRING DIAGRAMS
HIGH
TEMPERATURE
SAFETY SWITCH
ADJUSTABLE
THERMOSTAT
40°F - 85°F
(4°C - 30°C)
HIGH
TEMPERATURE
SAFETY SWITCH
WARRANTY
ADJUSTABLE
THERMOSTAT
40°F - 85°F
(4°C - 30°C)
constitutes
cadetheat.com/product-registration
6
3. Clean the unit with a damp cloth.
4. Turn power back on at the main disconnect
panel.
L2/N
L1
FP102T (dual element)
4. Cadet's
warranty is limited
replacement.
5. In the event Cadet elects to replace any part
of your Cadet product, the replacement parts are
subject to the same warranties as the product.
The installation of replacement parts does not
modify or extend the underlying warranties. Re-
placement or repair of any Cadet product or part
does not create any new warranties.
If you believe your Cadet product is defective,
please contact Cadet during the warranty period,
for instructions on how to have the repair or
replacement processed.
Parts and Service
Visit
cadetheat.com/parts-service
on where to obtain parts and service.
an
HIGH
TEMPERATURE
SAFETY SWITCH
ADJUSTABLE
THERMOSTAT
40°F - 85°F
(4°C - 30°C)
HIGH
TEMPERATURE
SAFETY SWITCH
ADJUSTABLE
THERMOSTAT
40°F - 85°F
(4°C - 30°C)
to
repair
or
for information
Rev 03/25/19
#720136
Advertisement
