Daikin Stylish Series Service Manual page 43

5 Pull down both locks on the back of the front panel.
6 Open the front panel until the support fits into the fixing tab.
a
a Lock (1 on each side)
b Backside of the front panel
c Fixing tab
d Support
INFORMATION
If you CANNOT find the user interface or you use another
optional controller. Pull the front panel carefully up by hand
as shown in the following figure.
To close the front panel
1 Set the filters as they were.
2 Lift the front panel slightly and remove the support from the
fixing tab.
a Backside of the front panel
b Fixing tab
c Support
3 Close the front panel.
4 Gently press the front panel down until it clicks.
To remove the front panel
INFORMATION
Remove the front panel only in case it MUST be replaced.
1 Open the front panel. See "To open the front panel" on
2 Open the panel locks located on the back side of the panel
(1 on each side).
(C)(F)TXA15~50A2V1B(W)(S)(T) + RXA42+50A2V1B +
RXA20~35A2V1B
Split Stylish R32
ESIE18-03 – 2018.09
a
b
c
d
3 Push the right arm lightly to the right to disconnect the shaft
from the shaft slot on the right side.
a
4 Disconnect the front panel shaft from the shaft slot on the left
side.
a
b
c
a
5 Remove the front panel.
6 To re-install the front panel perform the steps in the opposite
order.
To open the service cover
1 Remove 1 screw from the service cover.
2 Pull out the service cover horizontally away from the unit.
page 42.
2 Components
a Panel lock
b
c
a Arm
b Shaft
c Shaft slot
b c
a Arm
b Shaft slot
c Shaft
a
b
a
b
a
Service manual
43