Bifinett KH 1133 Operating Instructions Manual page 36

3. Starting Up the Device
Before starting up the device, make
certain that ...
– the device, power plug and power
cord are in perfect condition and ...
– all packaging materials have been
removed from the device.
Fill the device with water up to the MAX
mark and let the water come to a full
boil as described in the next section.
Pour this water away.
4. Boiling Water
Danger: Never place the electrical
base near water – life-threatening
danger!
You should only heat as much water as
you need directly. This saves energy,
water and time:
• Remove the kettle from the base
before filling it!
Press down on the lid handle to
unlock it. The lid then springs open.
Hold the kettle vertical while filling it.
Only then will the level indicator on
the side correctly indicate the amount
of water. Fill the kettle...
– to at least the MIN mark so that the
device does not overheat,
– no higher than the MAX mark so that
no boiling water spills out.
• First close the lid...
• Then place the kettle on the base
until it stands up straight.
Set the desired water temperature
with the temperature controller. The
temperature controller must be set to
the MAX setting to bring the water to
a boil.
t
• Now insert the power plug into the
power socket ...
and press down the switch until it
snaps into the depressed position.
A red light indicates that the device
is now heating up.
• The device switches itself off once the
water is at a full boil. The switch then
snaps back out and the red light goes
out.
To interrupt the heating, slide the
switch back to the up position. This
also causes the red light to go out.
Warning: Pull the power plug out of
the power socket before removing the
kettle from the base. This prevents any
water spilling out from falling on the
electrical connections in the base,
which could cause a short-circuit.
·
¿
36