Models - Graco XM Series Repair Parts

Models

Models
XM sprayers are not approved for use in hazardous
locations unless the base model, all accessories, all
kits, and all wiring meet local, state, and national
codes.
Check the identification plate (ID) for the 6-digit part number of the sprayer. Use the following matrix to define the
construction of the sprayer, based on the six digits. For example, Part XM1A00 represents an XM Plural-Component
sprayer (XM); 5200 psi pump set with pump filters (1); wall power supply, no heaters, no junction box, and is not
approved for hazardous areas (A); with no additional kits (00).
NOTE: Some configurations in the following matrix cannot be built. Consult with distributor or Graco representative.
To order replacement parts, see Parts section in this manual. The digits in the matrix do not correspond to the Ref.
Nos. in the Parts drawings and lists.
XM
First and
Second
System Choice
Digits
(See Table 1 for lower models)
Pump Set
(hose/gun)
1
5200 psi
2
5200 psi
XM
3
6300 psi
(plural
component
4
sprayer
6300 psi
mounted
on a frame)
5
5200 psi
6
5200 psi
7
6300 psi
8
6300 psi
Location Category Key:
NE Not for use in European explosive atmosphere locations or hazardous locations.
EH For use in explosive atmospheres and hazardous locations
10
1
Third Digit
Pump Remote
Filters Manifold
A

B
C

D
E
 

 

A
Fourth Digit
Kit Choice
Control Fluid Junction
Box Heaters Box
Wall Power
Supply
Wall Power

Supply
Wall Power

Supply
IS/
Alternator
IS/

Alternator
.
Approvals
Location
(See page 11
Category
for approvals)
CE, FM,
NE
FM
c
CE, FM,

NE
FM
c
CE, FM,
NE
FM
c
CE, FM,
EH
FM Ex
c,
CE, FM,
EH
FM Ex
c,
00
Fifth and
Sixth
Digits
Additional
Kit
See Table
2 for
selections
313289V