Set Up Or Change Transducer Settings (Advanced Settings) - Humminbird SOLIX Series Operation Manual

S C
ET UP OR HANGE
When you connect a transducer to a black box sonar or to the SOLIX control head, the transducer will be detected in the network
automatically. The best transducer source will be chosen and start pinging automatically. If you connect an accessory transducer
to the network, the unit will recognize the new transducer.
WARNING! The instructions in this section are advanced and not recommended for the typical user. Changing these settings
incorrectly could damage the transducer.
NOTE: For black box sonar and sonar networking information, see Set up your Humminbird Network. Also, to set up an Airmar
transducer, or for troubleshooting information, download the Transducer Setup Guide from our Web site at humminbird.com.
NOTE: Humminbird has provided the best settings for your unit. You can use the settings included with your control head, or you
can adjust these advanced options.
Set up or Change Transducer Settings
Use the instructions in this section to enable a transducer with its complete functionality.
1. Press the HOME key.
2. Select Settings.
3. Select CHIRP Sonar.
4. Select Sonar Source.
5. Select Initial Setup.
If the transducer has been set up, but you want to change a transducer setup setting, select the
Transducer Setup
T S
RANSDUCER ETTINGS
(not recommended)
transducer connection location
(connected to the selected SOLIX control head)
232
(A S )
DVANCED ETTINGS
menu icon.
Transducer
setup menu