Troubleshooting - Fujitsu Stylistic Manual

TROUBLESHOOTING

Causes and countermeasures for troubles you may encounter while using your wireless LAN are
described in the following table.
Problem
Unavailable
network
connection
Possible Cause
Incorrect network
name (SSID) or
network key
Poor radio wave
condition
Radio wave
transmission has
stopped
The computer to be
connected is turned
off
Active channel
duplication due to
multiple wireless
LAN networks
W i r e l e s s L A N U s e r 's G u i d e
Possible Solution
Ad hoc connection: verify that the network names
(SSID's) and network keys (WEP) of all computers to
be connected have been configured correctly. SSID's
and WEP key values must be identical on each
machine.
Access Point (Infrastructure) connection: set the
network name (SSID) and network key to the same
values as those of the access point.
Set the Network Authentication value identically to
that of the Access Point. Please consult your network
administrator for this value, if necessary.
For the method of setting network authentication,
refer to the following pages:· "Assigning parameters".
Ad hoc connection: Retry connection after shortening
the distance to the destination computer or removing
any obstacles for better sight.
Access Point (Infrastructure) connection: Retry
connection after shortening the distance to the
access point or removing any obstacles for
better sight.
To check the wave condition, refer to the following
pages:· "Confirming the status of the radio waves".
Check if the wireless switch is turned ON. Also verify
"Disable Radio" is not checked in "Network setting"
window. Refer to "Starting Transmission".
Check if the computer to be connected is turned ON.
If there is any other wireless LAN network nearby,
change channels to avoid active channel duplication.
For the method of checking active channels, refer to
the following pages:· "Confirming the status of the
radio waves".
61