Setting Up The Security Panel; Passwords - Fujitsu Stylistic Manual

SETTING UP THE SECURITY PANEL

When you receive your Tablet PC, the security
panel application is pre-installed without any
passwords. The following sections provide
detailed information on your security panel and
how to set, change or remove passwords.
Numbered Buttons
Use these buttons to enter your password.
Enter Button
After entering the button strokes, push this
button to enter the password into the Tablet
PC.

PASSWORDS

The user and supervisor password may be set
on this Tablet PC. A supervisor password is
typically the same for all Tablet PCs and
notebooks in a work group, office, or company
to allow for system management. Individual
computers in a group environment should not
use a common password. A password consists
of one to five button strokes plus the enter
button. A valid stroke consists of pushing one
or up to four buttons simultaneously.
The following are valid button strokes:
• Pushing [4] by itself
• Pushing [2] and [3] at the same time
• Pushing [1], [2], and [4] at the same time
• Pushing [1], [2], [3], and [4] at the same time
The following are valid passwords. The
numbers within braces ({ }) are button strokes
using more than one button.
• {[2]+[3]}, [1], [Enter]
• [4], [enter]
• {[1]+[3]}, {[2]+[3]+[4]}, [1], [4], [2], [Enter]
Setting Passwords
When the Tablet PC is shipped from the
factory, no passwords are set. You have a
choice of having no password or setting a
supervisor and user password. You must set
the supervisor password before the user
password.
G e t t i n g S t a r t e d
The purpose of supervisor password is
to be able to bypass the user password
in case the user password is forgotten.
The supervisor password alone will not
lock the system.
You must set the supervisor and user
passwords for the security panel to
work.
Setting Supervisor Password
You must have set a supervisor password
before setting any user passwords. The
supervisor password can bypass the user
password.
1. Go to the Start menu.
2. Click on Run.
3. Type in:
C:\Program Files\Fujitsu\Security
Panel Application\Supervisor\
FJSECS.EXE, then press [Enter]
4. Follow the on-screen instructions to set the
Supervisor password.
Setting User Password
1. Go to the Start menu.
2. Click on All Programs.
3. Click on Security Panel Application ->
Security Panel Application.
4. Follow the on-screen instructions to set the
user password.
You may change or remove the
supervisor or user password by
repeating the steps defined above.
19