Installation Instructions; Safety Requirements - Honeywell SLATE Series Installation Instructions Manual

KEYWAY FOR
1/8" SQ. X 1/2" LG. KEY
INSTALLATION
INSTRUCTIONS
WARNING
Read Carefully
Please read the operating and mounting
instructions before using the equipment.
Install the equipment in compliance with the
prevailing regulations.
Bedrijfs- en montagehandleiding voor gebruik
goed lezen! Apparaat moet volgens de
geldende voorschriften worden geïnstalleerd.
Lire les instructions de montage et de service
avant utilisation! L'appareil doit
imperativement être installé selon les
règlementations en vigueur.
Betriebs- und Montageanleitung vor Gebrauch
lesen! Gerät muß nach den geltenden
Vorschriften installiert werden.
NOTICE
Language translations for this document are available
at www.customer.honeywell.com.
6-11/16 (170)
2-33/64 (64)
5/8 (16) 61/64 (24)
Ø 1/2 (13)
3/32 (3)
Fig. 1. Dimensions in in (mm).
SLATE™ LOW TORQUE ACTUATOR SERIES
2-47/64
(69)
5-29/64
(138)
5-29/64
(138)
7/8 (22) 7/8 (22)

Safety requirements

WARNING
Safety Notice
The SLATE Actuator has been independently
evaluated by Underwriters Laboratories to
provide position feedback to the SLATE Fuel Air
Ratio Module. The safety of the overall system
is ultimately the responsibility of: 1) The
upstream safety control that commands and
monitors the SLATE Actuator, and 2) the
trained commissioning engineer that
configures the unit for system operation.
WARNING
Safety Hazard
Before operating this product, check all
specifications and safety requirements to
ensure the product is suitable and safe for the
intended application. In addition, read all
installation, commissioning, and operating
instructions. The SLATE Actuator must be set
up and maintained in the field by qualified
personnel. If the equipment is used in a
manner not specified, the protection provided
by the equipment may be impaired.
3
(2) Ø 7/8 (22)
KNOCKOUTS
FOR 1/2"
CONDUIT
ENTRANCE
1-11/32
(34)
M35299
32M-06009—06