HP AlphaServer ES47 Upgrade Manual page 37

1. The IDE cable was plugged into the I/O Expander board in Section 2.7.
2. Place the CPU on the module guides and slide it into the drawer.
3. Make sure both ejector handles catch on the compartment sides and close the handles
pressing the module into the connector on the backplane.
4. Replace the two screws to the right and left of the handles on the CPU module
the four screws on the CPU
5. Replace the CPU compartment cover and tighten the two ¼-turn screws.
The ES47 M2 system is now ready to be installed into the rackmount cabinet.
.
Prepare the System
and
2-19