Mounting Dab 402 - Dometic DAB402 Installation And Operating Manual

Mounting DAB 402

6 Mounting DAB 402
I
NOTE
• Only install the device, if you already have some previous experience in fitting
car radios, if this is not the case, have the device installed by an expert instead.
• The device should be installed behind the instrument panel or in the glove
compartment.
• If a DAB window-integrated antenna is stuck onto a metallic dampened window
pane, then reception quality may be impaired.
6.1 Mounting receiver
➤ Fix the receiver in place behind the instrument panel or in the glove compartment, e.g. using
a cable tie.
➤ Connect the receiver to the DAB connection on the main unit.
6.2 Mounting antenna
!
WARNING!
Mount the antenna so that it does not impair the driver's field of view.
Observe the following mounting instructions:
• Choose a mounting environment with ambient temperature and normal air humidity.
• Mount the antenna in an upright position.
• Maintain a distance of at least 50 mm to other antennas.
• Do not mount the antenna on ceramic lines, heating filaments or AM/FM antennas in the glass.
• Try not to mount the antenna more than once, as it may be damaged by doing so.
• Do not use any glass cleaning agents or solvents immediately after attaching the antenna.
• Route the antenna cable so that it does not impair vehicle operation.
• Make use of existing holes and passages.
• Do not roll up the antenna cable.
• Make sure that the antenna cable or the antenna are not detached when you are cleaning or
maintaining the antenna.
• Make sure that fluid is not sprayed onto the antenna branching area.
➤ Choose a suitable position for the antenna (fig. 2, page 3).
➤ Remove any dirt or dust fro the window.
➤ Fasten the antenna temporarily into place on the window using adhesive tape.
➤ Route the antenna cable.
➤ Connect the antenna cable to the DAB+ receiver.
➤ Stick the antenna onto the window.
8
DAB402
EN