Thread Plate - Janome JP720 Servicing Manual

Mechanical Adjustment

Thread plate

When the hook of the threader plate is damaged, change or adjust the part as follows.
To change the threader plate:
1. Raise the needle to its highest position and lower the threader knob
w
2. Loosen the screw and remove the threader plate
To adjust the needle threader:
r
1. If the hook of the threader plate slashes or hits against the left or right side of the needle eye, loosen the
screw and adjust the hook position (Fig. B).
2. If th hook of the threader plate
t
the screw and move the position setting plate up pr down to adjust the hook position (Fig. C).
q
Adjust the direction of up or down (Fig. C)
t
e
slashes or hits against the top or bottom side of the needle eye, loosen
Position setting plate
q
to its lowest position.
e
(Fig. A).
To change the threader plate (Fig. A)
e
r
Adjust the direction of left or right (Fig. B)
19
w
e