Indicators On The Control Panel - Fujitsu PRIMERGY RX2520 M1 Operating Manual

Starting up and operation
6.1.2.2

Indicators on the control panel

Power-on indicator (three colors)
– Lights up green when the server is switched ON.
– Lights up orange when the server is switched OFF, but mains
voltage is present (standby mode).
I
With firmware version 7.3.x or higher, two new operating conditions
are indicated: iRMC booting and power-on delay.
– Flashes yellow / orange: iRMC booting
I
– Lights up yellow: power-on delay
I
HDD/SSD activity indicator (green)
Lights up green when an internal drive (HDD or backup drive) is
being accessed.
62
After connecting the server to the mains, it will take about
60 seconds until the server will switch into standby mode.
After connecting the server to the mains (power cord
plugged in / after mains failure) the iRMC will boot. The
system cannot be switched on, until the iRMC boot
sequence is complete. During this time, the power-on
indicator will flash yellow / orange.
After shutting down, the server cannot be switched on
again right away. If the On/Off button is pressed right
after shutting down the server, the power-on indicator will
light up yellow until the delay period ends and the server
will boot.
Operating Manual
RX2520 M1