Table of Contents
Advertisement
END PLUG (COLLECTOR BUNG) ASSEMBLY – CONETITE FITTING
Refer to
installation diagrams
page 29.
1.
Place the collector bung of the end plug (5) assembly into the collector
connection and screw in the gland nut until it seats firmly against the
collector connection, applying medium pressure with a spanner to tighten.
DETAIL D – END PLUG (COLLECTOR BUNG) ASSEMBLY
CLAMPING COLLECTOR TO COLLECTOR RAIL
Refer to
installation diagrams
page 30 and
Detail F
1.
Centre the solar collectors on the collector rails (1).
2.
Position the collector clamp (13) over the hole in the collector rail (1) with
the top lip of the clamp over the collector trim.
3.
Insert the hex screw through the hole in the collector clamp and collector
rail (1), place the washer and nut on the screw and screw the nut until it
seats firmly against the lip of the collector rail, applying medium pressure
with a spanner to tighten.
on
pages
CONETITE FITTING
on
pages
on page 30.
29
CONNECTION DETAILS
36
to
38 for position and
36
to
38 for position and
Detail D
on
Detail E
on
- Quick Links:
- Components and Kit Contents
Hide quick links:
Advertisement
Table of Contents
