Create User-Defined Pin And Lock The Device; Profisafe Commissioning; Activate And Parameterize Profisafe With Simatic Pdm - Siemens SITRANS P Series Supplement To Operating Instructions

1.6.2

Create user-defined PIN and lock the device

Requirement
The device is in the "S1" PROFIsafe commissioning state.
Procedure
1. Click on "Device > Extended Write Protection > Change stored PIN" in the menu bar.
2. Press the button "Enter new number for stored PIN".
3. Enter the desired PIN under "New Value".
4. Press the "OK" button.
5. Press the "Close" button.
6. Click on "Device > Extended Write Protection > Perform locking of the device".
7. Press the button "Perform locking of the device".
8. Press the "Close" button.
1.7

PROFIsafe Commissioning

Requirement
Before you commission the PROFIsafe device, configure it in Step7 – for example.
Process
Activate and parameterize PROFIsafe with SIMATIC PDM (Page 1-7)
Commission PROFIsafe with SIMATIC PDM (Page 1-8)
Check write protection with SIMATIC PDM (Page 1-10)
1.7.1

Activate and parameterize PROFIsafe with SIMATIC PDM

Procedure
1. Press the "Upload to PG/PC" button.
2. Under ">> PROFIsafe", set the "PROFIsafe activation" parameter to "Yes".
3. Set the parameter "F_Dest_ADD" so that it is equal to the value in the HW Config.
SITRANS P, DS III PROFIsafe series
Supplement to Operating Instructions, 03/2006, A5E00732533-01
The "Input" dialog box is opened.
The "Input" dialog box is closed.
SIMATIC PDM reads in the parameters from the device.
PROFIsafe
1.7 PROFIsafe Commissioning
1-7