Table of Contents
Advertisement
RUGGEDCOM RS910W
Installation Guide
Figure 3: Panel Mounting
1. Screw 2. Panel Mount Adapter
3.
Secure the adapters to the panel with #6-32 screws.
Section 2.5
Connecting the Antennas
The RUGGEDCOM RS910W supports two dipole antennas that can be rotated 360° around the connection point,
and up to 90° at the joint for optimal positioning.
NOTE
The RUGGEDCOM RS910W is shipped with two 2.4 GHz dipole antennas.
NOTE
For technical specifications, refer to
To connect the antennas, do the following:
1.
Make sure the operating frequency range of each antenna is compatible with the device.
2.
Align the antenna connector with the wireless port (either TX/RX or RX) and thread the antenna onto the
port. Make sure the connection is finger tight.
Connecting the Antennas
1
1
Section 4.3, "Wireless Ethernet
2
2
Ports".
Chapter 2
Installing the Device
11
Advertisement
Table of Contents
