Editing Your Voice Commands - Sony Ericsson Z525a User Manual

To activate voice answering and
record voice answer commands
1
} Settings } General
the
} Voice Answer } Activate.
2
Instructions appear.
tone and say "Answer", or another word. If the
recording sounds ok
repeat step 2.
3
Say "Busy", or another word
4
Instructions appear.
the environments in which you want voice
answering to be activated. You can select
several alternatives.
To answer a call using voice
commands
When the phone rings, say "Answer" and the call is
connected.
To reject a call using voice
commands
When the phone rings, say "Busy". The call is
rejected. The caller is forwarded to voicemail,
if activated, or hears a busy tone.
This is the Internet version of the user's guide. © Print only for private use.
} Voice Control
tab
} Continue. Wait for the
} Yes. If not } No
and
}
Yes.
} Continue
and select

Editing your voice commands

You can edit all your voice commands saved in
Address Book. Select the contact you want to edit
} More } Edit
a voice command for
to the relevant tab and edit your voice command.
To re-record a voice command
1
} Settings } General
the
} Voice Dialing } Edit
2
Select a voice command
3
Wait for the tone and say the command.
Tips when recording and using voice
commands
If your phone cannot detect your voice command,
one of the following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should
be around one second long and more than one
syllable.
• You spoke too late or too soon – speak immediately
after the tone.
Calling
Contact. Scroll
} Voice control
tab
Names.
} More } Replace Voice.
27