Lexus RX450h Dismantling Manual page 39

32. REMOVE REAR SEAT ASSEMBLY LH
(1) for Power Seat:
a) Lift the seat track adjusting handle and move the rear seat assembly LH to the foremost
position.
(2) Disconnect the rear seat airbag assembly connector under the rear seat assembly LH.
Notice:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
a) Push down the white housing lock and slide the
yellow CPA. (At this time, the connector cannot
be disconnected yet.)
b) Push down the white housing lock again and
disconnect the connector.
Notice:
Do not push down the part (A) shown in the
illustration when disconnecting the connector.
(3) Disconnect the connector.
(4) Remove the rear center seat inner belt assembly
from the rubber band of the rear seat cushion
assembly RH as shown in the illustration.
(5) Lift the seat track adjusting handle and move
the rear seat assembly LH to the foremost position.
(6) Remove the 3 bolts.
A
Rubber Band
35
White Housing Lock
Yellow CPA