Introduction; Ancillary Options - Lochinvar SST66 Installation, Commissioning, Maintenance And User Instructions

1.0

INTRODUCTION


The Lochinvar SST range is a Stainless Steel direct storage vessel, featuring a 100mm clean out
access opening to enable inspection of the internal surface of the vessel.

A pocket for installing a temperature control device (aqua stat) and drain valve are also fitted.

There is a single boss providing the facility for immersion heater installation as standard,
further bosses can be added at extra cost at ordering stage.

All installations must conform to the relevant Building Regulations.
requirements must also be taken into account when installing any equipment. Failure to
comply with the above may lead to prosecution.

If the equipment is to be connected to an unvented (pressurised) system, care must be taken
to ensure all extra safety requirements are satisfied should a high or low-pressure condition
occur in the system.

1.1 ANCILLARY OPTIONS


6kW 415v Immersion heater 15"

9kW 415v Immersion heater 16"

9kW 451v Immersion heater 21"

12kW 415v Immersion heater 24"

18kW 415v Immersion heater 27"
Health & Safety
CSI107
CSI111
CSI112
CSI115
CSI416
3