To Install Mitre Table And Fence - Ryobi BT3100K Owner's Operation Manual

■ Check to make sure the rail clamps will securely clamp
the rail before sliding the entire assembly into position. If
not, tighten the square rail holder nut one-fourth (1/4) turn
and recheck.
■ Slide the rail into position over both clamps and secure.
■ Mount the rear rail, following the same clamping procedure
as shown for the front rail. Orient the rear rail as shown in
Figure 12.

TO INSTALL MITRE TABLE AND FENCE

See Figures13 and 14.
■ Install the sliding mitre table assembly over the front and
rear rails. See Figure 13. Check that it slides easily on the
rails. Push both front mitre locking clamps down evenly
on each side to secure. Repeat for both rear mitre locking
clamps.
Note: DO NOT force mitre locking clamps fully down.
Tighten only to flat "seated" position.
■ To install the mitre fence holder to the mitre fence, loosen
the attachment bolt by turning the adjusting clamp (the
knob on top) counterclockwise. Make sure the adjusting
clamp is loose enough so the bolt has enough clearance
to slide in the table slot. Slide the tabs into the grooves
in the mitre fence. See Figure 14.
■ Mount the mitre fence to the mitre table by installing the
locator pin (below the mitre fence) into hole "A" or "B".
(Hole "A" is closest to the blade.) At the same time, place
the attachment bolt in the slot. Secure the adjusting
clamp, but do not tighten.
■ Adjust the mitre indicator to the scale.
■ Securely tighten the adjusting clamp.
END PLUG
FRONT
RAIL CLAMP
HANDWHEEL
BEVEL
LOCKING LEVER
ASSEMBLY
FRONT RAIL
SCALE
BLADE
ADJUSTING
HANDLE
Fig. 11
RAIL
HOLDER NUT
REAR RAIL
FENCE HOLDER
MITRE FENCE
MITRE
INDICATOR
HOLE "B"
QUICK
STOP
Page 16
REAR RAIL
END PLUG
ADJUSTING
CLAMP
MITRE
HOLE "A"
TABLE
SLOT
Fig. 12
MITRE
TABLE BASE
Fig. 13
ATTACHMENT
BOLT
LOCATOR
PIN
Fig. 14