Step G: Mounting Parts On The Accessory Mounting Plate; Step H: Connecting Power - Hughes 9250 Quick Install Manual

Land mobile satellite terminal

Table of Contents

7. Insert the battery into its slot in the terminal and lock it in place. Close and

lock the battery door.

Step G: Mounting parts on the accessory mounting plate

Use the parts in the

vehicular install kit

(stand off, screws,

lock washers, and tie

wraps) to mount the

parts to the accessory

mounting plate.

Insert the power supply plug into the vehicle 12 Vdc accessory outlet. This can be done with or without

initial power to the 12 Vdc outlet supply

Note: You can operate the terminal without a battery, but Hughes recommends operation

with a battery installed for a graceful power down if power is disconnected.

The terminal cannot operate solely on battery power. The antenna requires power from the

vehicular power source.

The terminal can be operated while the battery is charging.

Your vehicle's battery may be drained if the terminal is used without running the engine.

3500145-0001 Revision A

Table of Contents