11-2.Function Settings By Using Remote Controller - Fujitsu ASTG30KMTA Design & Technical Manual

11-2. Function settings by using remote controller
Some function settings can be changed on the remote controller. After confirming the setting proce-
dure and the content of each function setting, select appropriate functions for your installation envi-
ronment.
NOTE: Incorrect settings can cause a product malfunction.
 Setting procedure by using wireless remote controller
The function number and the associated setting value are displayed on the LCD of the remote
controller. Follow the instructions written in the local setup procedure supplied with the remote
controller, and select appropriate setting according to the installation environment.
Before turning on the power of the indoor unit, reconfirm following items:
• Cover for the electrical enclosure on the outdoor unit is in place.
• There is no wiring mistake.
• Piping air tight test and vacuuming have been performed firmly.
• All the necessary wiring work for outdoor unit has been finished.
After reconfirming the items listed above, turn on the power of the indoor unit.
NOTES:
• Settings will not be changed if invalid numbers or setting values are selected.
• When optional wired remote controller is used, refer to the installation manual enclosed with the
remote controller.
Entering function setting mode
While pressing the POWERFUL button and TEMP. (
button to enter the function setting mode.
Selecting the function number and setting value
1. Press the TEMP. (
switch between the left and right digits, press the 10 °C HEAT
button.
2. Press the POWERFUL button to proceed to value setting. To return
the function number selection, press the POWERFUL button again.
3. Press the TEMP. (
switch between the left and right digits, press the 10 °C HEAT
button.
4. Press the MODE button once to send the function setting informa-
tion. Confirm that you hear the beep sound.
5. Press the START/STOP button to fix the function setting. Confirm
that you hear the beep sound.
6. Press the RESET button to end the function setting mode.
7. After completing the function setting, be sure to turn off the power
and turn it on again.
) ( ) buttons to select the function number. To
) ( ) buttons to select the setting value. To
- 31 -
) button simultaneously, press the RESET
Function number
Setting value