Curtis G4 TPX 1 User Manual page 9

INSTALLATION INSTRUCTIONS
Connecting the Brewer Wiring (Units That Come from
the Factory Without a Power Cord Attached)
WARNING: Do not connect the power cord to the
power supply until instructed to do so.
Brewers With Power Connector Mounted to the Back
11 Connect a C20 IEC power cord (not supplied)
compatible with the electrical outlet installed in the
Brewers With Strain Relief Mounted to the Back
12 Remove the front panel by removing the screws that
hold it in place.
13 Loosen the strain relief on the back of the brewer.
14 Feed the power cable into the brewer. The brewer may
be wired for connection directly to a junction box or for
use with a power plug that connects to an electrical
outlet meeting the brewer SPECIFICATIONS.
15 Connect the wires on the power cable to the terminal
ELECTRICAL SCHEMATIC.
16 Tighten the strain relief and replace the front panel.
Electrical Connection
Connection to a Junction Box
WARNING: Turn off power to the junction box at the
circuit breaker panel and lock out and tag the
circuit breaker before connecting the power cable
to the junction box.
17 Connect the power cable wires to the terminals in
the junction box and replace the cover. See the
ELECTRICAL SCHEMATIC for the power supply
requirements.
Back of
brewer
Front
panel
block
Power cable
II9
or
082019C