Curtis G4 TPX 1 User Manual page 10

INSTALLATION INSTRUCTIONS
Connection to an Electrical Outlet
18 If not already installed, install the appropriate type of
power plug for your locality. Consult local electrical
codes to determine the approved type of power plug
for your region.
19 Connect the power plug to the appropriate electrical
outlet.
WARNING: Connect the power cord only to the
compatible, either have the cord replaced or have
the electrical outlet upgraded by a licensed
electrician. Do not use an extension cord. Do not
Powering up the Unit
20 Turn on the water supply valve.
21 Make sure that the circuit breaker supplying power to
the unit is on.
22 Turn the toggle switch on the back of the brewer to the
to the PROGRAMMING GUIDE section and program
the brewer for the correct model and batch number.
23
volume, the heating elements will turn on automatically.
Depending on the incoming water temperature and
requires 20 to 30 minutes to reach the factory set
"Ready to Brew" should be on the display.
IMPORTANT:
elevations, reduce the default operating
1000 feet (300 m) of elevation above 4000 feet
(1200 m). See PROGRAMMING GUIDE.
24
of hot water through the hot water faucet to help purge
air from the tubing inside the brewer.
25
remaining air from the tubing. See OPERATING
INSTRUCTIONS. During the initial brew cycle and
water tank.
II9
Back of brewer
082019C